bateau2 Advertisement
  Home arrow Plan Updates arrow Small Boats arrow FS12 and FS14 stringers
Menu
 Home
 Builder galleries
 Message Board
 How To and Tutorials
 FAQ
 Plan Updates
 Boat Plans
 Boat building materials

Specials


In Our Forums

Newsflash
Read about the new biaxial tape for small boats.
See the complete article in the updates section.

 Thursday, 15 May 2008
FS12 and FS14 stringers pdf  print  E-mail
Monday, 25 September 2006
Bottom panel butt block interferes with stringers. To notch or not?
The FS12 and FS14 hull panels are assembled with butt blocks. The butt blocks are located strategically between the mid seat frames. This makes them invisible.
On the bottom side, there is a pair of stringers that push against the bottom and we do not show a notch over the butt block.
That small 1/4" (6 mm) gap is well within our tolerance and will be filled with the fillet putty later.
It is not necessary to notch the stringer at the butt block location. You can notch the stringer if you want but it is not required.
The building notes of plans shipped after October 1st 2006 will mention that interference and the option to notch the stringers.
Last Updated ( Monday, 25 September 2006 )
 
 
Go to top of page  Home | Builder galleries | Message Board | How To and Tutorials | FAQ | Plan Updates | Boat Plans | Boat building materials |