|
|
|
|
|
Monday, 25 September 2006
There is a panel label mistake and confusing dimensions on the Otter plans.
For all plans shipped before September 26th 2006.
On the hull panels drawing, the labels "chine panel" and "topside panel" are inverted. The panel at the top is the topside panel.
It was impossible to make an assembly mistake because the panels would not fit but it confused at least one builder.
The dimensions for the bottom panel were shown in a weird way. The bottom panel is symmetrical and instead of measuring from a center line, dimensions were given for the two sides! Plus, the 2nd last point towards the bow on the upper side was off by 1/2". The dimension for the same point on the lower side was correct.
All this as been revised. |
| Last Updated (
Monday, 25 September 2006 ) |
| |
Plan Updates 
Home | Builder galleries | Message Board | How To and Tutorials | FAQ | Plan Updates | Boat Plans | Boat building materials | 
Sunday, 11 May 2008
