bateau2 Advertisement
  Home arrow Plan Updates arrow Power Boats arrow FS17 - missing dimensions
Menu
 Home
 Builder galleries
 Message Board
 How To and Tutorials
 FAQ
 Plan Updates
 Boat Plans
 Boat building materials

Specials


Low shipping cost

In Our Forums

Newsflash
Read about the new biaxial tape for small boats.
See the complete article in the updates section.

 Thursday, 15 May 2008
FS17 - missing dimensions pdf  print  E-mail
Friday, 06 July 2007
Some dimensions for the bow mold are missing.
Some dimensions for the bow mold are missing from plans shipped before July 7th 2007.
Sheet 284/4.
Bow mold: the height of the chine intersection is 12-5/8" (332 mm)
The baseline is at 3" (78 mm) above the lowest point.
That one is not really needed but can be used to check other dimensions.
On the transom drawing, the half width of the cut is 16" (406 mm)
It shows somewhere else too.
Last Updated ( Friday, 06 July 2007 )
 
 
Go to top of page  Home | Builder galleries | Message Board | How To and Tutorials | FAQ | Plan Updates | Boat Plans | Boat building materials |